โMay-14-2020 11:16 AM
โMay-21-2020 08:41 AM
โMay-20-2020 07:15 AM
โMay-20-2020 06:21 AM
โMay-15-2020 11:10 AM
Executive wrote:dougrainer wrote:
.../snip/ because I made sure the side Camera's had there own 12 volt supply. Doug
Maybe that's the key here; Obviously it's a wiring issue. So that, then, begs the question. Was the system wired correctly? Can you wire the system without providing power individually to each camera? Perhaps the OP skipped or modified a step. :h ....Dennis
โMay-15-2020 08:46 AM
dougrainer wrote:
.../snip/ because I made sure the side Camera's had there own 12 volt supply. Doug
โMay-15-2020 08:01 AM
rgatijnet1 wrote:dougrainer wrote:
Per the Instructions, IF YOU DO NOT USE THE TRIGGER HARNESS(connecting the trigger wires) THE TURN SIGNALS SHOULD NOT AFFECT THE OPERATION. If the Camera's have there own 12 volt supply and not connected to the original Furrion harness, the system should operate as the OP desires. You do NOT have to use the Trigger harness for install. Doug
Well then they should be working, right???? :B
โMay-15-2020 04:24 AM
dougrainer wrote:
Per the Instructions, IF YOU DO NOT USE THE TRIGGER HARNESS(connecting the trigger wires) THE TURN SIGNALS SHOULD NOT AFFECT THE OPERATION. If the Camera's have there own 12 volt supply and not connected to the original Furrion harness, the system should operate as the OP desires. You do NOT have to use the Trigger harness for install. Doug
โMay-14-2020 03:11 PM
โMay-14-2020 01:06 PM
โMay-14-2020 11:57 AM
โMay-14-2020 11:34 AM