cancel
Showing results for 
Search instead for 
Did you mean: 

TBI Min idle speed spec

udidwht
Explorer
Explorer
Looking at the 1994 service manual for 454 TBI under fuel systems (Section 4-4A) the 'Min idle speed' setting is... (Factory set screw)

For the 7,4L auto trans in Drive is 625 (+-25rpm) Closed loop

Controlled Idle Speed is as follows:

454 7.4L in Drive 675 (+- 25rpm) IAC count 5-30 (Closed loop) at operating temp 196-222F (add 2 counts for every 1000ft above sea level

The 'controlled idle speed' is obtained by the control module positioning the IAC valve. A high/low coolant temp or AC clutch engagement may signal the control module to change the IAC counts.

IAC counts will be above 60 if idle is too low and zero counts if idle is too high. Things to check if so...

1. Vacuum leak/s

2. System too rich

3. TB obstruction

4. PCV issue

5. AC issue
1994 Fleetwood Southwind Storm
P-30 chassis 7.4L 454 TBI 58,301 miles and counting....(as of 06/08/19)
VIN# 1GBJP37N4R3314754
Flight System Generator man 360 (PM me)
2 REPLIES 2

udidwht
Explorer
Explorer
opnspaces wrote:
Is there a question in this post or is it just information?


Just info. I've seen and been asked of it often enough that I figured it would be good to post it up.
1994 Fleetwood Southwind Storm
P-30 chassis 7.4L 454 TBI 58,301 miles and counting....(as of 06/08/19)
VIN# 1GBJP37N4R3314754
Flight System Generator man 360 (PM me)

opnspaces
Navigator II
Navigator II
Is there a question in this post or is it just information?
.
2001 Suburban 4x4. 6.0L, 4.10 3/4 ton **** 2005 Jayco Jay Flight 27BH **** 1986 Coleman Columbia Popup