Tee Moulding

[agesilaus]

How do you keep this moulding in the slot? I have a couple of piece that came off and do not want to stay in. Brads? Glue?

[Darklock]

Oops, I was thinking the trim piece cover screws on outside of trailer.

[RLS7201]

My "T" molding is held in place with small staples at the bottom edge.

Richard

[capacitor]

Ahh, counter top edge molding. Use silicone and duct tape to hold it till dry.

[capacitor]

Can you post a picture?

[agesilaus]

Edit: OP, do you mean the moulding that goes from carpet to linoleum and slips in a track?

No, one is around the bathroom sink and the other around a small cabinet top

[capacitor]

Normally, the silicone is only used at the ends and 90’s.

Edit: OP, do you mean the moulding that goes from carpet to linoleum and slips in a track?

[Darklock]

I had this problem. When build, for some reason they put silicone in there to hold the molding in. When it needed replaced, I had to scrape all of the old silicone out of the grooves to get the new molding to stay in at road speeds. Talk about a pain in the butt.

[BarneyS]

Moved to Tech Issues forum from DIY.

[opnspaces]

It's best to just replace with new molding.
Amazon