Starting a new post.Bought a used 3000is, was told it has been sitting for 1yrs.Things that I did to it:*Carb rebuilt*Fresh new gas*New spar plug*Fresh oil (FILL TO MAX & OVERFLOWED)*Check valves to make sure it open & closeSymptom: Oil Alert will fl...
Well, I just bought a used Honda EU3000is. When bought the seller told me that it has been in storage for 1yr and gas tank is empty. The engine do spin freely and has compression.Got it home, fill it with fresh gas and change oil and check for sparks...
Another question: If the coil kill wire is grounded, that mean the engine will not run. But if measure from gound to kill wire only get 1 ohm, pretty much it ground correct? or all it need is to be around 1 ohm to be good.I remove the IC and measure ...
OK.. So without the elcetrical connected, gas or carb. I aseembly the pully back to the motor and confirmed that with 17.4Kohm on the secondary and 1.0 ohm on the primary.I start pulling on the rope and check for spark, no spark. I remove the spark a...
quick little update: 30min later, Strange, now I get resistance on the cap assembly. It first read 21k and after playing with it and hook it back to the IC, it now read 9K by itself and when attached to the IC the total read 17.4KStrange????? I'll re...
Robert-Thank you!!! very much for the service manual. I did a bit more test before, I get to read your attached service tips. I removed and install back the IC and I found that, my primary coil is 1.0ohm (now) and my seconday is 8.2Kohm (@tip of #1 l...
