Hello All, I need some help. I have a 2004 HR endeavor. The air dump doesn't work. It used to work. It did have a blown fuse.So I replaced that and it still isn't working. It hasn't blown since I put a new one in. I'm having a hard time identifying t...
Hello,I have a 2004 HR Endeavor 40PRT. I'm looking to get a hardwood laminate installed. Looking at the main slide, I think it just drags along the floor. One service center said they would need to install rollers to keep the floor from getting scrat...
Hello All,Thinking of buying a 2004 HR 40' Diesel. It has Canada plates and owned by folks in Arizona. It was originally registered in AZ. They are going to take it to Phoenix customs to enter it to the US. Now I would like an idea of how much it wil...
dougrainer wrote:hries wrote:I finally found all 3 solenoids. I was getting no power to the dash switch. The dash switch is working. So I found a hot wire to get power to the switch. It popped the fuse. I disconnected all 3 solenoids and tried it aga...
I finally found all 3 solenoids. I was getting no power to the dash switch. The dash switch is working. So I found a hot wire to get power to the switch. It popped the fuse. I disconnected all 3 solenoids and tried it again. This time it didn't pop t...
dougrainer wrote:1. Loose ground will NOT cause a fuse to blow. 2. Monaco products(Roadmaster) the Air dump is indeed SLOW, that is a design function3. I never paid attention to, if the system had more than 1 solenoid for manual dumping. I always hea...
ILVMYGT wrote:I had that problem. They tied the grounds for the solenoid together and the ground was loose. I tighten the ground and it solved the problem.The manual showed where the solenoids should be, but the front seemed to have only one pressur...
I found a floor installer that will do it for me. He said the vinyl planks should not be glued down. He said he leaves a 1/4" gap at the edges fro expansiona nd cotraction.
