Onan Microlite KV - model 2.8KVFA26100K - spec K Generator was starting and running 120 no load 115 load for 20 minutes and would die. Gradually reduced running time to under 2 minutes. Now will start and run only with the start button down...
I am trying to test the rotor and stator on a Microlite 2.8. The service manual says to use a megger or the highest scale if not using a megger. Trying to test for a grounded rotor - manual says not less than 1 megohm. Has anyone had any experien...
I have an Onan Microlite - I am wondering if instead of replacing rotor and stator if I can have these sent to a repair shop to check and repair. If so, do any of you know of a quality shop?Thanks,Robert DavisPS - I don't see the need to spend 7-800...
I have an Onan Microlite 2.8KV that starts and runs for about 20 minutes then dies but immediately restarts. It will run for about 5-10 minutes and die again. This is the sequence.I have replaced the plug, fuel filter, fuel pump, air filter, and ch...
Hello everyone. I am the guy with the microlite 2.8 that starts and dies. I pulled the coil and the primary read 0.8 ohms and the secondary 1,150 ohms. There is a test for the voltage regulator but it requires a diode test meter. I installed a...
