Flying out to purchase a 2008 Tiffin Phaeton 36 QSH.Are there any issues or concerns with this model?http://www.tiffinmotorhomes.com/pdfs/specs/2008phaetonSpecs.pdfThanks in advance.
Anyone with first-hand experience / recommendations for a supplemental brake system for a 2008 Jeep Grand Cherokee (Diesel)?I'll be towing it behind a Class A Diesel with the 43K GCWR Freight-liner chassis (10K hitch) w/air brakes.I'm reading my way ...
Many split-bath floor-plans have the shower "in the hallway" and the head behind a closed door. Fan is typically in head.How do you remove the shower steam moisture with this design? Seems one would have to close bedroom and living room sliding doo...
Hi,Going to look at a used 2006 34' HR. ~40K miles. Nada Retail $.What are your opinions on this model? Pros/Cons?1. Roadmaster 204" chassis: GVWR 26.500. GCWR 33,000. Front 9500. Rear 17,000. 22.5" tires.7K towing.Is Roadmaster comparable to...
Clam Quick-Set Escape screen tent60 second one-man setup. Seriously!Typical laborious tent assemblyThe Clam screen tent is awesome! It really does set-up in about one minute. Best camping purchase I've made. Highly recommended, though not cheap.C...
rk911 wrote:I would not install diodes into the current wiring but instead install a totally separate wiring harness and a set of extra bulbs in the taillights. when you're hooked up to the MH the umbilical will use the separate wiring harness and bu...
Open your side window and lean out to view the front corner of the MH, mirrors and the front tires. Go Slow and keep the front corner at 4" from fence.I've currently got the same parking situation. Have to miss a mailbox, then a light-post, then a ...
Thanks. Just joined that forum.I'm aware of the 3 "house" issues. Roof-to-side "caps" (aka rails) cracking, wet bay (replace plywood w/plastic) and drivers slide potential leak affecting floor. First 2 were fixed, 3rd inspected and OK.Found a link...
Thanks for the endorsements and installation tips. The Ready Brute Elite is being used by many knowledgeable members so looks like a good option (KISS). I'll also buy a temperature gun to ensure the activation cable isn't too tight.Thanks again!!
