Hi guys. I have a Anderson Ultimate Aluminum hitch ball in box mount and very happy with it! Only minor issue is when I am unhitching the ball gets hung up on the adapter till it finally releases after lifting truck up small amount. I've backed up tr...
I purchased a 2009 Cardinal had them change tires as 8 yrs old. ST 235-80-16 were stock tires recommend 80psi for max load for rim of 3100 lbs. they changed tire and put on ST 235-85-16 max on sidewall of 95 psi and for load 3800 lbs. I went to,tire ...
I want to install a quick change on my propane line so I can connect my BBQ.. I have removed the regulator on the BBQ so I want to install quick change on line from propane tank. Where have you folks installed it?
Just had my first trip with 2014 3500 Ram Diesel pulling 2009 34' Cardinal. Pulled great up some long 6-7% grades left in tow haul mode kept it at 55 mph no problem! When going down hill with exhaust break on and in tow haul it slowed down too much. ...
I have a 2014 Dodge Ram 3500 20" tires. When towing I run 80psi in rear tires and 65 in front as per tire specs. Now when Not Towing I want to reduce rear psi to 65-70psi to,reduce bumpy ride. Any thoughts, any buddy doing this?
Anybody have a tip for not hitting thr 5er when backing up with tailgate down? When going straight back I have no problem as I have a noodle pushed on my Anderson ball so I stop when I’m touching pin but when I am at an angle I’ve come very close to ...
Yes my pin box is at the lowest setting. It is welded to this setting so cannot move. I had to raise my fiver 5 inches to get level. I have 7 inches of bed rail clearance. Looks and pulls good. In hindsight I should of looked at replacing the trailai...
I have the AUH and love it. I have a 2014 Ram 3500 regular box and have the hitch ball on the highest setting. I would like to drop it down has I have to raise the 5th very high to hook,and unhook. I don't no how any one can drop hitch ball to,lowest...
I unhitched again and did,same thing got slightly hung up. I kept raising the landing gear and it released. I guess overall it's not a big deal. I changed my landing gear to the bulldog dual motor system and it lifts with no problem so lifting the tr...
Yes my release cable is all the way out. It is always easy to pull the cable. I'll try spraying the ball with silicone to see if that works? Maybe a spray of silicone to the release cable from inside the adapter may work to. I'll give Anderson a call...
