I have an automatic door lock on one of my cargo doors that won't open. I hear the mechanism working when I hit the unlock button on my remote, but the rod that holds the door locked won't retract. Any suggestions?
One of my carefree power shades on the front windshield has stopped working. I took it apart and found that the problem is in the small round motor that slides into the left side of the housing. Does anyone know if it is possible to order just the ...
My coach has 3 zones but only two (front and back) for furnace. We are currently traveling in cold weather and the rear zone works great but the front is not blowing anything at all and doesnt come on automatically when the temp on the thermostat is...
Went boondoggling this weekend and cranked up my Onan 10,000 generator to run the ac. Only had one unit on along with the bedroom tv. After about 20 minutes the tv cuts off. Checked the inverter/charger and the red light was on with the monitor re...
Last year I took my coach into my dealer for some routine engine maintenance. I had them reseal my roof around edges and around ac's etc. He told me I needed to do it once a year due to Florida sun and heat. Its been over a year and the seals stil...
Thanks for the tip. I will try opening up the lock panel on the inside of the door and see why its sticking before I take the door off. Since I hear the mechanism clicking when I hit the remote, Im hoping its just a minor problem. My auto lock sys...
The furnace is a hydro-flame on a 45' sportscoach. Manual suggests checking breaker in furnace compartment which I did and all seems ok, but the one side still wont come on. Tommorrow will be in warmer climate so I guess I will wait to get it check...
flexseal makes a mess, but I guess if you don't have anything else it would work in an emergency. I don't know why it bubbles up when you spray it, since you don't see that on TV. Anyway, lap seal is the best and you should keep a couple of tubes o...
I will probably call Magnum per your suggestion and talk to a tech to see if its the FET board. Can't seem to think of anything else it could be. Everything works great on shore power. And now that you mentioned it, the monitor read "overheat" not...
