While pondering the EU2200i placement around the rear bumper, it dawned on me I could easily lower the compartment shelf where the old Generac was. Fasten aluminum diamond plate to welded angle iron, provide a slot that could be opened during operati...
The shop reported just now the engine has seized. They are not enthusiastic about repairing it. But things are not entirely hopeless since I've unstuck engines before on really old International Farmall engines. I mean really stuck.PB Blaster and ...
You've heard it, smoking sooty flames from the water heater exhaust. Even burned wires! Well the round brush cleaned out the funnel web from a spider and now clean flames, bluish yellow, perfect. I just need the inline fuse. Watch those stinkin' ...
Ah I have it nailed, tow our little dog trailer to carry the gen, gas, water and tons of gear. We can even run it in one of the four compartments for security and sound deadening. It’s like our own little utility toad.
Thank you. I'll tear into it in the coming weeks. I'm strongly considering a Honda or Yamaha 2000w replacement and fab the existing genny box to properly secure the 2000w unit. Then also changing out the AC to a lower amp unit.
With the unit starting up, check for voltage across the gas solenoid, if you don't have voltage to open the valve, then you have either a terminal corrosion problem or the control board is bad. I had this problem and replaced the board for the fix. ...
