My tow vehicle is an Astro van and it doesn't offer much in the form of gauges or monitoring for the drive train. Dash real estate is also pretty limited, so I decided to add some "glass" to create an information center for monitoring critical stuff ...
I've been lurking, on and off, here for many years. I've learned a lot and thought I'd provide some ideas inspiration to others. This was an easy project and only cost about $30 in materials to make. Any decent fabricator could do something similar f...
Lantley wrote:Arvika pin box mount. bike rack. No bouncing or shaking bikes are always in view bikesThe Arvika stuff is nice, but spendy. Although, it wouldn't be too hateful to copy their design and integrate a 2" receiver to use an off-the-shelf hi...
BB_TX wrote:I did something similar with a little different approach.$20 receiver from Harbor Freight and some 2x2 angle I had laying around. Drilled holes to match the pin box bolts. Did not want to drill into my air ride pin box.Shown mounted. Moun...
SWD wrote:OK...if you had a long box.Fortunately, I do have the long bed. I think that this could work with a short box truck, but you'd be limited to two bikes or would have get the rack up higher.
agesilaus wrote:Good ideaOoops... I should have mentioned that I was inspired by another poster...There's a couple of other folks here who have done something similar.
