Hi Everyone!I used to have a '08 GMC 2500HD short bed with an Extang RT low profile tonneau cover on it. We towed a 30ft Weekend Warrior 5th wheel with it. Worked fine, until I impacted the rails of the cover with the hitch pin on a couple tight tu...
I have a rubber propane line on one of my slides that has a kink in it. While I've tried to re-route it so it doesn't pinch, the kink in the line isn't going away, and causes the line to kink anyways.Gonna just replace it. Was gonna go with a steel...
We installed a 2nd AC in our 30ft Fifth Wheel a couple months ago. Decided to go with the Penguin II low Profile 13.5 BTU over the bedroom area.Everything seems to work, it powers on and you can tell a difference when the compressor kicks on, but it...
Have a 2016 Keystone Cougar that was wired for the 2nd AC.Last weekend, removed the vent and put up a 2nd AC, an Dometic Penguin II.Fairly easy to do, but getting the old sealant off was a pain. And in some places, it just didn't come off (it was st...
So, my 2009 WW Sl3005 has some soft spots in the floor. Slowly getting worse. Store a 2011 RZR in it and, even though I put down wood to distribute the weight, made some more soft spots.So, I know the right way to do it, tear it up and replace it. ...
MNRon wrote:Can’t comment on the roll-ups your interested in, but want to suggest an alternative. I’ve had a 3-fold TonnoPro on my 2013 Silverado SB for 8 years and love it. It was less expensive than most. The soft vinyl cover holds up well (3-4y...
Roger10378 wrote:There are several videos on u-tube showing the sealing of the air passages to correct the problem. I would start there. If there is air leakage between the cold air and the return you will get those exact symptoms.I gave my main 15...
Roger10378 wrote:There are several videos on u-tube showing the sealing of the air passages to correct the problem. I would start there. If there is air leakage between the cold air and the return you will get those exact symptoms.Thanks. Good adv...
4x4van wrote:Don't overtighten the A/C unit. Just a turn or two past snug is all you want.Good advice! The directions actually had a torque setting in there, 40-50 inch lbs, so followed that.
Thanks everyone.Went with the 4" tape around the opening, then the AC unit on top. While I haven't driven anywhere, seems to hold up to the rain storms we've had.Hopefully it works out, a little bothered by how much the roof material bunches up on t...
