Hi everyone, it's been awhile. I have a new to me trailer and have run into a problem:The bedroom slide will not move on 12v power. It just clicks. The kitchen slide works fine on 12v so I don't suspect the battery but it's possible. The bedroom slid...
Dear lord I have searched and googled, but I cannot find an answer.I am adding a small solar system to my trailer (I have done previous systems in previous trailers) and rather than connecting my controller to the batteries (difficult wire run) I'm w...
I am going to do my best to describe the situation, so please bear with me.When I pull the rod out of my water heater to drain, the outside edge of the flashing used to house the water heater is diverting water back into the trailer onto the floor un...
I have a stinky (mild rotten egg smell) water heater on my trailer that I need to deodorize with hydrogen peroxide. I am thinking of filling the water heater through the pressure relief valve. But I don't know the thread size to buy to appropriate fi...
One of the sockets (the square tube where the bar is inserted) moves freely back and forth. The other will not move at all without the leverage of the bar installed for help. Neither situation seems normal to me. I have reached out to the manufacture...
So this is an ongoing problem. Sometimes the slide works, sometimes it doesn't. I have verified full voltage at the motor. When it get stuck in the "in" position, I can turn the nut on the shaft a few times with a wrench to get it to move under elec...
jdc1 wrote:eHoefler wrote:All systems on the trailer are 12 volt. Since it operates when plugged in, it will be a battery issue. Have your battery tested, if over 3 years old, replace it.I agree. Try using a different battery (even your truck batte...
Flyfasteddie wrote:If you can get to your converter you can tie in to the battery connection there.My solar panel is right above my converter which is about 15' horizontal from the battery. Instead of running additional cable to the battery I just r...
ScottG wrote:From the factory they use silicone and lots of it. It's a good location for silicone. It doesn't see UV and it can stand up to being under water.That's a good idea.
