Our trailer has a B&B remote bypass valve. As I was winterizing today, I went to switch back to normal mode to allow some antifreeze into the heater tank, and the handle broke off inside the valve, popping it apart and squirting from pump pressure.So...
I had read a lot on here about people doing a disc brake upgrade from drums. I kept struggling with the cost of it, but when I needed the brakes done anyway, we decided to go the extra and get discs. I got them from Ron at Performance Trailer Braking...
I got luck with my tire. Just as I was pulling into the campground yesterday, I got a low pressure alarm on my tire monitors. After we parked and sat around a while, I looked over and the tire was completely flat. It wouldn't hold air either. This mo...
I passed one of these yesterday, on I26 between I95 and Columbia, SC. I hadn't seen one of these. It looked so small and narrow from the back, then I saw it was a 5er. It was being pulled by a S10.Cute "little" thing.ScampMark
We are going to be going through Atlanta the second week of January. We won't be pulling the 5er this trip, but I figured there are a lot of people on here that travel through there.I have two choices as to when to do it. We will be leaving Ohio Mond...
SCClockDr wrote:Is the valve that failed a 3 way or open/closed?It’s a plastic bodied 3 way. One valve to bybass the heater, instead of two like the ones that mount right at the tank. I did figure out I can get to tank mounted valves from inside, if ...
Maybe I didn’t note it clearly. My bypass valve isn’t located at the water heater. It’s a remote valve located in the docking station in the basement, ten feet away from the water heater. If the valve was on the water heater, I couldn’t get to it to ...
The purpose of the valve is to not have to fill the water heater with twelve gallons of antifreeze. I was just putting a little in, to make sure the lines from the valve to the tank had antifreeze.
I just looked on their web site, and there is a dealer just east of Cincinnati. I didn't see the model you are looking for in their inventory, but they do list 2018 models as on order. You might contact them. I think I'll check them out, I'm in Ohio,...
When I did this to ours, there was a sticker on the junction box cover where the new AC was going, listing max amperage. So I had to stay under that. I put a 13.5k unit in, and that is big enough.Mark
