I have a bit of a head scratcher. I have a Progressive Industries HW50C and have made my own neutral bonding plug. I’ve use that plug with my old Yamaha EF2400iS (2007 USA model) generator without issues or codes on the PI unit. Got a new to me EF300...
Just announcedKENNESAW, Ga., Jan. 14, 2019 -- Yamaha Motor Corp., USA, introduces the all-new EF2200iS to its line of portable inverter generators. The value-packed inverter offers high power and bold features in a reliable, quiet and compact package...
Ordered a new set and it’s new stock. Install instructions are revT 2017. This kit has the rivenuts in it. Holding the frame brackets onto my frame and they do not appear to bent to the full 90 (I have radius corners). Seems like 88 degrees. I’m worr...
Keystone should be shoot.Every seam is calked with SILICONE even the roof seam at the gutter. I have spent weekends removing it and calking with ProFlex on the sides and windows.What's the best way to remove it from the roof without damaging the memb...
Found this handy chart on the net. Looks like it will cover just about all trailers and 5th wheels. The numbers will work for CR, SKF Timken's etc.PDF Link
To close this story off. I got the new brackets and installed them today. The new brackets where definitely at 90. The photos kind of show how the old ones where well over 90.
Yes I did not get why they said that either.Anyway this is actually my second dual cam setup. My first one was a round bar and now have the titan 17K. Hopefully the new cam kit will square.
Reese is now sending me a new dual cam kit. Was not easy. Had to send proof of purchase and photos of the issue first. And they believe it would not case any issues they way it currently is!
Thanks for all your feedback. I’ll call Reese today. The brackets are the issue. Finally took some photos. Since the cam arms are at different angles I think they are loading one bar more than the other. And yes I have the bars marked L and R!
Yes I’ll call then again. I do have the same one as yours on the right hand side with the welded inside 90. The outside bend is the issue it’s not at 90. The radius is good and is not interfering with the corner of the frame. I also have the nutcerts...
