Here is a little info on a cheap product that works great for me.Velcro type double sided hook and loop tape. Hooks on 1 side and loops on the other. best thing of all CHEAP!!http://www.harborfreight.com/3-4-quarter-inch-x-35-ft-roll-hook-and-loop-ca...
Just looking at the design scares me away from that jack foot extension. The offset design builds in a side load that will push the trailer forward when you load the jack. Gotta chock it.I will admit that I learned the hard way, with a flip foot exte...
I would not drill out the frame member any more than needed. I would through bolt the brackets with good stainless carriage bolts. I am assuming that you are screwing into an aluminum frame member next to the opening. Make sure to caulk up your repai...
Man what a problem to have.;) From what I see you have a huge amount of choices. I have a 29 ft Keystone Outback 298RE which is touted as 1/2 ton towable, (Barely). I pull it with an 08 GMC crew 5.3 v8 3.73 rear with heavy duty towing package. I adde...
I have a Keystone Outback 298RE and use the stock stabilizer jacks. I added the "Steadyfast stabilizer system, as well as 2 extra jacks directly in front of the front axle for fine tuning the level of my trailer when parked. When set up properly my ...
What I believe you are talking about is actually a circuit breaker in the 12 volt main. go back again and look at the wiring.I bet you have a cable that has gone to ground somewhere. my T/T has one as well. Trace the positive cable back to your inver...
