cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

Furnace will not light

vaminniewinnie
Explorer
Explorer
I just purchased a 1997 minnie winnie a couple months ago. The furnace will not come on. Checked fuse.
8 REPLIES 8

vaminniewinnie
Explorer
Explorer
Thanks for the help from everyone. Thanks to the replies, I found the problem, bad thermostat.

Bordercollie
Explorer
Explorer
If you are handy, and can get to the circuit board, pull it out of connector and clean the contacts, re-insert. Also, check 12 volt wiring connections, may be loose or corroded. If you don't hear a sizzle sound when starting furnace, the ignition circuit may not be working. Should also hear a mild clunk when gas valve opens. There may be an air bubble(s) in the propane lines that prevent gas flow and ignition. It sometimes helps to start stove burners or water heater to get gas flowing to furnace. The "sail switch" or gas valve may be stuck. Burner gas orifice may be plugged. Furnaces have many safety features that prevent starting if there is anything wrong. There are You Tube videos on furnaces that may help you DIY. Don't risk fire, etc. Get a qualified RV service to fix the furnace if in doubt.
May cost $200+ if they have to remove furnace for diagnosis and repair.

ronfisherman
Moderator
Moderator
Please stay on topic.
2004 Gulf Stream Endura 6340 D/A SOLD
2012 Chevy Captiva Toad SOLD

Cousin_Eddie93
Explorer
Explorer
What make? Suberban? Does the electronic ignition engage, click click click or not. If no click make sure the igniter is not obstructed or contact very dirty. If so clear and clean. Otherwise you may have a bad ignition circuit board, Been there done that. $100 bucks to replace. Unless you can find used, basically any suburban board will do, furnace, water heater don't matter if that is your brand which most were back then.

GMandJM
Explorer
Explorer
Post deleted for health reasons. (As moderated, it was nauseatingly twee.)
G-half can always find a way to do things upside-down, inside-out or backward.
It's his Super Power!

midnightsadie
Explorer II
Explorer II
light the stove let lit for about two minutes, that,ll bleed air out of the line, retry furnace , make sure you open the tank valve. and be a little patient blower will blow then it should light. light.

DrewE
Explorer II
Explorer II
What exactly does the furnace do or not do? Does the fan blow but the flame not light, or does it fail to do anything at all?

I assume the answers are probably "yes," but...do the other 12V systems work properly? and likewise the other propane appliances?

enblethen
Nomad
Nomad
Welcome to RV.net!
Check the thermostat for on/off switch
Next remove cover from the thermostat, locate the two wires going to the furnace, connect them together, furnace should start and produce heat shortly.
Didn't start? Open access for the furnace. Look for a circuit breaker mounted to the fan housing. Should have reset button.
Check for incoming power.
What make and model of furnace?

Bud
USAF Retired
Pace Arrow


2003 Chev Ice Road Tracker