I've searched, but can't seem to find this exact situation, everything seems more global.
After de-winterizing my trailer a few weeks back, I was flushing the lines and all the faucets (kitchen, bathroom, shower and toilet), both hot and cold were flowing just fine.
I got sidetracked and a week later I went back and directed water back into the hot water heater.
From my recollection, it seems that after I filled the hot water heater, my kitchen faucet started spurting, and now does nothing. Both hot and cold water. Not sure if those two things are related or not.
I was just back out in my trailer. I hooked up city water, the kitchen faucet dribbled a little water, then dead again (my city water feeds almost directly into my kitchen faucet for cold). No apparent leaks anywhere.
My faucet has both a hot and cold on/off.
All the other faucets/toilet, both hot and cold are working from both city and the fresh water tank.
I see you solved your problem but I will tell you of another.. This applies only to those kitchen faucets where the head pulls out and doubles as a sprayer.
There is a check valve in the head where the hose connects.. It too clogs up.
Home was where I park it. but alas the. 2005 Damon Intruder 377 Alas declared a total loss after a semi "nicked" it. Still have the radios Kenwood TS-2000, ICOM ID-5100, ID-51A+2, ID-880 REF030C most times
Would you think that when you filled the wH, that it washed the sediment off the bottom and right into the faucet ? Does that say its been a while since you drained the WH ?
Rich
'01 31' Rexall Vision, Generac 5.5k, 1000 watt Honda, PD 9245 conv, 300 watts Solar, 150 watt inv, 2 Cos 6v batts, ammeters, led voltmeters all over the place, KD/sat, 2 Oly Cat heaters w/ ox, and towing a 2012 Liberty, Lowe bass boat, or a Kawi Mule.