cancel
Showing results for 
Search instead for 
Did you mean: 

Jayco electrical problem

robdnorm
Explorer
Explorer
I have a 2011 Jayco TT. I had the interior lights on that operate off the entry switch as soon as you enter. This panel has two switches. One controls the exterior light as well. When I turned on the exterior light, the interior lights went out as well as exterior. I checked the fuse and it was not blown. As a backup, I put a new one in. This did not fix anything. Today I replaced the switches on the recommendation of the dealer. The lights worked and were fine for a few minutes until I turned them off. When I went back later to turn them back on, they were dead again. I checked the fuse and it is not blown. The dealer is backed up two months on service work. Any ideas where I should start trouble shooting?
2 REPLIES 2

myredracer
Explorer II
Explorer II
Sounds like a bad/intermittent splice. Could be behind or near the switched. Sometimes there's a bunch of slack wire shoved in behind switches and lights. Pull out any slack wire and see if there is a wire nut in there. Try and find the un-switched hot wire behind the switches and the ground and see if it is always on.

Could be a bad splice downstream somewhere in which case it may or may not be straightforward to find. You could try doing a test by finding 12 volts from another source nearby and connect it to the switches and see if the lights stay on. If you can find another 12 volt source nearby that you can run wires from concealed, you might want to just abandon the existing 12 volt supply to the switches/lights and connect to a new source (cap off old wires).

A photo might help and also a model number so photos can be looked up. If the switches are on the end of a cabinet, there could be a hollow cavity underneath that already has wires in it and they are likely easy to access.

enblethen
Nomad
Nomad
Start by checking each of the lamps. Make sure they match the socket. That is some have two pins on bottom and some have a single pin. If a single pin is installed in a two pin socket, it will short out.
Next check the wiring. Find the incoming hot wire. It should be jumpered between the two switches. The other side of the switch should go to the corresponding lamp.
My first thought is wrong lamp!

Bud
USAF Retired
Pace Arrow


2003 Chev Ice Road Tracker