PCV flagpoles

[prujak]

I made a couple of these flag poles and get allot of questions and comments about them. I fly an American flag and WVU flag. I used 1" pvc pipe since I am using 3' X 5' flags.

These are simple to make if you can cut and glue pvc pipe.

Since flag day is coming in a week June 14, I thought it would be nice to put this information up again.

I will be flying my flags this way at Whispering Hills RV Park in Shreve Ohio.

http://www.rv.net/forum/index.cfm/fuseaction/thread/tid/26548164/gotomsg/26548197.cfm#26548197

http://www.rv.net/forum/index.cfm/fuseaction/search/parms/sw%7Bpvc%20flagpoles%7D%7Ckm%7Bexact%7D%7Ckl%7Bm%7D%7Cfm%7B%7D%7Cpd%7B365%7D%7Cma%7B%7D/sr/1.cfm

Hope I did this right. I should start selling these.

[prujak]

Robin1953

Thanks for your help. Don't know what I was doing wrong.

[Robin1953]

prujak wrote:

Hope I did this right. I should start selling these.

There was a guy in Myrtle Beach selling them for $25 with the cheap flag, rod and washer included.

[Robin1953]

Clicky 1
Clicky 2

[prujak]

If you glue everything but the bottom of the "T" than drill a hole through it and use a pin everything holds together well. Sometimes the wind can whip it around and the parts not glued might come apart. Than you can store it in two sections.

[skipnchar]

I've used PVC for the purpose before but never bothered gluing anything together. Slipping them together allows them to be broken apart for transport and does little to effect their strength.

[prujak]

I have tried the two links and they won't open for me. Try searching for pvc flagpoles.