Would like to know if anyone has added an in-line booster pumpon their f-53 fords to increase fuel pressure and how it worked out before I go thru dropping the tank etc. I'm getting only 20# at the fuel rail and should be getting 35-45#. I've seen th...
Does anyone know what the correct fuel pressure should be for a96 class A efi 8 cyl.engine? I'm only getting 20 lbs max. Looks like I need a new fuel pump. Thanks
I was having a starter problem and installed a new starter. when I try to start, It engages but doesn't crank the engine and sounds like it would with a nearly dead battery. the battery is new and fully charged, all connections are clean and in good ...
PROBLEM SOLVED. I installed a Carter in-line fuel pump rated at 75gph. and 45psi. I wired this pump thru a new circuit from the starting battery using a new 30 amp cube relay with the circuit fused @ 15 amps to prevent overloading the original circu...
Thanks again for the info., I'll check it out. I'll probably go with the one you used since you had good luck with it in your rig. I'm also going to replace the throttle position sensor as that can also cause hesitation on acceleration. It's not expe...
Thanks again for the info. I think I'll give it a try. I'm considering an MSD Ignition High Pressure Pump rated at 43 gph and 40# pressure. If possible, would like to know which pump you used for your installation as I would like to compare the specs...
PROBLEM SOLVED!!!! I re-checked ALL wiring connections and added an additional GROUND CABLE from one of the starter mounting bolts to the frame. I also found some oxidation on the starter cable connector at the solenoid on the starter so I replace...
Thanks again for the info. I'm sure this pump is due to be replaced and I will check out the regulator also. I would love to install a booster pump on the frame rail but I don't think It can draw thru the original pump. If anyone has tried this, I wo...
