For years, I had been trying to think of a way to add some counter space to my RV in the space where a slideout passes the cabinet. There was almost a foot of wasted space there. I had considered some type of drop-down shelf or removeable shelf, bu...
I recently installed a finned aluminum differential cover from PML Covers on my 2012 Chevrolet Avalanche 1500 that I intend to use for towing a travel trailer. In my previous truck, I had to replace the differential bearings, which is not a small ta...
The main shelf in my Dometic refrigerator has a big gap in it, supposedly to accommodate tall items on the shelf below. The problem is that we never need that feature: tall bottles fit well in the door. So normally, there is just a big hole in the ...
Like many campers, my rig has a panel behind the stove that the manufacturer calls a "knife holder." The trouble is, that the slots are too large and the panel too thin to hold anything securely. The knives were always leaning over and the short on...
There are some trouble-shooting manuals on-line that may help you.I assume the freeze sensor goes to a control board that controls the compressor, etc. The next step is probably to trouble-shoot or replace the control board.
I have never seen a breaker that used screw terminals. They all have clamps where you push the wire straight in the side and screw a clamp down on top of it.
The devices that have the wire wrap around a screw are not appropriate for the vibration environment in an RV. You need to choose ones with screw clamps, often labeled as "commercial". Even back-stab connections are more reliable than wrapped screw...
I was going to have mine re-upholstered, but I found one on-sale at Camping World, so i just replaced it. The cost was in the $500 US price range.If I wasn't restricted by the wheel-well, I would have changed to a recliner set-up, but I had to stick...
