97 Bounder, keep hearing a "tunk" followed by a "click" every few minutes under the hood when plugged into power. Sounds as if an automotive circuit breaker in the control box keeps tripping then resetting. Is this normal? If it is a breaker, how can...
Bought the Airlift kit for the front springs on the Bounder. Started working on it today. They claim one hour each side.....@&$:;( Took me 6 hours just to get the OE dry rotted/spring formed bags out! I haven't attempted to insert the new bags yet. A...
Removed couch from 1997 Bounder to install carpeting. When I went to remove it, I noticed the forward bolt behind the driver seat was in front of the couch frame, just sticking up. The other side behind the dinette was only secured with one bolt in t...
Roof on my motorhome is black because the OE coating has since worn away. I am going to be putting eternabond on all seams, vents, etc. is it ok to use the tape prior to re-coating roof or should I tape after? Just trying to do the restore in increme...
I acquired a 97 Bounder and there are two of these things on the wall. One is on a wall above the dinette on top of the air conditioner and heat buttons, the other is in the bedroom on a wall by the door. It looks like where you'd wrap a rope tie ...
enblethen wrote:It should not be cycling from shore power, only from alternator charge circuit.Did you find make and model of battery control center?It's an RV Custom Products and the circuit board is a CB-115 rev A
It's a brand new chassis battery. I don't know how old the 6v coach batteries are though. Could one or both be bad and cause that to continually cycle? It has a separate converter charger for those but I didn't know if it would cause it to click some...
I learned the silver cylinder coil is the charging and auxiliary start solenoid/relay. It makes sense that it is clicking only when plugged in since it is the charging relay. Should it be clicking though like that?
It's an RV Custom Products CB-115 from what I can get off the board. There is a diagram on the inside of the control box cover as well. There are two breakers mounted to the top of the control box that appear to be paralleled. I put my fingers on the...
Got it installed. Two people makes for easier work (at least to roll the bag into a hot dog shape and zip tie it! Didn't take but about 1/2 hour to install the bags on each side. I used Ru-Glyde tire mounting lubricant (I mount my own motorcycle tire...
