We were caught in a torrential downpour while returning home from a trip. We were in it for about 40 minutes. The engine (Cummins ISB 340) lost power twice within several minutes. It continued running, but no response to the throttle for several s...
At the end of the last trip, the gen set was running when I activated the leveling system at home. The interior lights were on at the time and completely darkened when the pump kicked in, and the gen stalled. Had to hook to shore power to get enoug...
Motor replaced last fall. It has worked properly all season. While prepping for a departure in a couple days I see that neither the inside nor outside switch will activate the motor. I confirmed the power switch is on, and it shows the red light. ...
I am pulling a 5,600 lb. toad with a 23,000 lb MH. The toad has the Unified Brake System installed. When I apply the MH brake, or manually activate the toad brake through the remote console, everything appears to be working, but I never have any se...
The trouble came after we were on a county road that was collecting water, so there would have been plenty of splashing.I've got some scheduled service coming up, and I'll ask the mechanic to take a look at the wiring.Thanks for the tip.
I do have a house battery that is not holding a charge. But I thought that the gen would boost/take over. Maybe not??This is an Onan 6KW Model 6 HDKAH-1044K
Some digging showed that there is no control box for this unit. There is just a relay behind the switch panel. I climbed up on top and tested the two exposed terminals. I measured +- 12V when the extend/retract switch is pressed, so there is power...
Tearing apart the motor cover is doable, but taping the control box seems like a simple first test. Where is that control box normally hidden, and what does it look like?Thanks,
