Our new to us 2018 KZ 2500 Durango came to us with a Curt A25 hitch. I am looking at different trucks to pull my Durango utilizing the A25 hitch. Do you know if you can attach the A25 on a slider base to use in a short box truck? Currently, the hitc...
If you own a 2018 Durango 2500 325RLT please comment Good/Bad/Ugly regarding your experience. Also, any tips on what truck you use to haul the rig. Thanks in advance.
Replaced model SW6DE with SW6DEL. I am now testing prior to caulking the unit in place. The gas heating works perfectly. I shut off the switch that controls the gas side of the heater and let the water cool. I then flipped the switch on the unit to t...
We are heading south on I44, and planning an overnight stay near St Roberts MO. Our son is currently stationed at FT Leonard Wood. Would appreciate any suggestions on where best to stay with our 5th wheel. After a quick visit we are continuing on dow...
I called Curt Customer Service and talked with Jason who was very helpful. He confirmed the Curt A25 w/legs for Ford F350 puck system will fit in either short/long Ford beds newer than 2011. Curt also makes a slider (#16020) that can use the A25 head...
Chris Bryant wrote:Probably the easiest way would be to pull it out and bypass the relay- it looks like the relay is in the hookup box, with a black wire in and black wire out (ignore the orange and yellow wires). This will basically convert it to a ...
Chris Bryant wrote:Heff560 wrote:Chris Bryant wrote:Did you rewire adding a new 12 volt switch hooked to the new orange wire on the unit?The extra orange wire was a bit confusing when rewiring. Using figure 4 on page 7 of the included instructions, ...
Re wiring the new HW Heater: the 120 side was straight forward, black to black, white to white and attached the ground to the box. The 12 v side had an eXtra orange wire on the new heater. I have no switch to wire this to. What should I have done wi...
four22 wrote:I'm not being smart but is the switch IN the water heater on? We have the same water heater in ours and its tricky to see the switch...See pic below:Yes, that switch is in the on position. I believe the issue may well be the 12v orange ...
