One of our Rieco-Titan Jack Motors has been acting up. It began by working intermittently. I could get it to run by "slapping" it, but this weekend after a short run to Kenai, I went to unload the TC and the one motor wouldn't run. I had previousl...
Atwood makes electric jacks. Here is a Link. I’m not recommending this vendor but did notice they show the mounting plate with hole pattern. Not sure what brand you are referring to but they probably also show the mounting plate with its associated h...
The center of gravity of the camper should be over the rear axle. Too far behind the axle and you will be faced with steering problems. The camper should have the CG marked on it or available from the manufacturer. Hitch extensions derate towing capa...
The motor plate attached somewhere on the a/c unit should have both the starting load and the running load. Kayteg1 is correct regarding actual vs design but unless something is significantly wrong, they will be close to the same.
Happi Jac calls for 40a supply from the battery to the circuit board. Assuming each motor draws equally (they won’t due to the differing weight each jack lifts), the individual current being drawn would be 10a. No explanation for “flat” battery being...
Bedlam wrote:Prior to 2012, the manual said not to take it off the truck with full tanks without supporting the bottom. Later models can be used with tanks filled or empty while unloaded. Is the model you want with a wet bath or dry? The wet bath giv...
