Jan-24-2016 03:19 PM
Jan-29-2016 12:17 PM
Jan-28-2016 11:29 AM
Jan-28-2016 11:01 AM
Jan-27-2016 04:07 PM
Jan-27-2016 12:16 PM
Jan-27-2016 09:07 AM
RangerEZ wrote:sfpcservice wrote:
Update:
*** I discharged by batteries yesterday and then charged them via the converter overnight, much like I did before the start of our trip. I went out this morning with the hydrometer and the batteries are only showing a charged state just above dead!!!
After reading the handy bob article, I started thinking about my stock converter placement. It's towards the rear while the batteries are near the front. So my thoughts are the converter is seeing the voltage come up high enough to drop into float mode, but due to the long wire run and voltage loss the batteries never get the charge the converter thinks they have. I'm guessing we left for our trip with nearly dead batteries and whatever charge we did get was from the truck on the drive down.
My next project will be relocation of the converter within a couple feet of the battery box...
That project may be worthwhile, but maybe not necessary. Let's get some basics covered so we can better help you.
1) What kind of batteries do you have?
2) What kind of RV do you have?
3) What kind of converter is in that camper?
My Trojans took far more than overnight to get back to full charge on the camper converter. I used to give them two full days. Even out of the camper with a smart charger, it took 24-30 hours. 6 volt batteries take a while...
When you say you discharged them, what was their measured voltage at discharge?
What was the measured voltage after your overnight charge?
Jan-27-2016 08:42 AM
sfpcservice wrote:
Update:
*** I discharged by batteries yesterday and then charged them via the converter overnight, much like I did before the start of our trip. I went out this morning with the hydrometer and the batteries are only showing a charged state just above dead!!!
After reading the handy bob article, I started thinking about my stock converter placement. It's towards the rear while the batteries are near the front. So my thoughts are the converter is seeing the voltage come up high enough to drop into float mode, but due to the long wire run and voltage loss the batteries never get the charge the converter thinks they have. I'm guessing we left for our trip with nearly dead batteries and whatever charge we did get was from the truck on the drive down.
My next project will be relocation of the converter within a couple feet of the battery box...
Jan-27-2016 08:15 AM
Jan-26-2016 10:37 AM
Jan-26-2016 09:11 AM
Jan-26-2016 08:52 AM
Happy Prospector wrote:DownTheAvenue wrote:
And therein lies your problem. With 12 volt batteries, you double your amp hours when connecting two batteries. With 6 volt batteries, the amp hours of both batteries remains constant while the volts double.
So, if you had two 210AH 12 volt batteries, you had 410 AH of juice. With the two 210AH 6 volt batteries, you had 210AH of juice.
IMHO, 12 volt batteries are always a better choice.
A 210 AH 12 Volt Battery? That's one big battery.
I do believe Downtheavenue may be Educated Beyond His Intelligence.
Jan-26-2016 08:45 AM
okan-star wrote:DownTheAvenue wrote:sfpcservice wrote:
I recently upgraded from 2 12 volt marine cranking batteries to 2 6 volt golf cart batteries rated at 210AH.
And therein lies your problem. With 12 volt batteries, you double your amp hours when connecting two batteries. With 6 volt batteries, the amp hours of both batteries remains constant while the volts double.
So, if you had two 210AH 12 volt batteries, you had 410 AH of juice. With the two 210AH 6 volt batteries, you had 210AH of juice.
IMHO, 12 volt batteries are always a better choice.
Have to disagree with thatlook here
Jan-26-2016 06:29 AM
Jan-25-2016 02:26 PM
Golden_HVAC wrote:
. . .The load is 0.8 amps per hour. . .furnace is an additional 6 amps each hour. . .old lights add 1 amp per hour. . .new LED's are only about 0.2 amps per hour