HAHAHA @Rick Jay. I can relate
๐I tried to take pictures but there was just too much glare and I did not have room to get it right.
So here is what I have so far;
There is a company online that specializes in skins for refrigerators and other appliances. They run about $90-$100. Not bad. That is a possibility.
I put the word out in my area for metal work to make new panels, but that has not produced any results yet.
I took a maroon scotch-brite for metals and a block of wood and lightly ran it straight up from bottom to top to even out the previous marks I had put on. I am now looking online for the best topcoat to put on over that, as once I went over it with the maroon pad it did not look as horrible as before. There is a spot on the lower corner that I had taken it down to the black steel, (practicing with different pads), so I am going to try to fudge that spot with a Stainless Steel or Metal Flake paint. I figure now I am going to see what it looks like after I topcoat it, and if it is still not to my liking I will purchase a vinyl skin. They have all sorts of designs, and lots of artwork, so that could actually be kind of neat looking. I do not know if I can say what that company is on this forum, so maybe PM me if you are interested.
I so wish I had researched the Dometic fridge more, and that the Platinum Stainless Steel is actually a coating on black steel. I would have saved myself so much grief.
Does anyone here know of a good topcoat for what I am doing? I am not sure if Krylon or Rustoleum are actually the products I want to use. Maybe I am over- thinking this.
Thanks again for all the suggestions, and some needed comic relief. Oh if only I could go back in time
๐
Alan & Sharon