cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

Skylight shattered

EMPIRE_LI
Explorer
Explorer
Bad storm today a branch fell and shattered our skylight. How hard is it to replace? The inside is undamaged just need a new dome on the outside. Thanks for any help in advance
2004 Chevy Tahoe lt 2009 29bhs Coachman
Reese wd
Honda 3000
5 REPLIES 5

darealmccoy
Explorer
Explorer
Have you checked with your insurance company? This is covered under comprehensive. If you have a low deductible, have them handle it. I would at least get an estimate from a RV repair shop and weigh the options.

Dave

Dave and Anna McCoy

:B :W
2012 Coachman Concord 301SS
2013 GMC Terrain Denali

nremtp143
Explorer
Explorer
I just did one on my toy hauler last week. It is easy to do, just take your time. There is a 4 part series on YouTube that I found after I did mine. Here is the first part RV Skylight replacement
2016 Montana 3790RD, Legacy Edition, G614s, TST TPMS
2008 Thor Vortex 26FS
2013 F350 DRW 6.7L 4x4, Edge CTS, B&W Companion, Viair 10007 Air System, Firestone Air Bags
2001 Excursion Limited 7.3L 4x4, V/B Springs
2001 Silverado 3500 DRW CCLB 8.1L/Allison 4x4

Smax
Explorer
Explorer
Just did mine.

Just takes lots of patience. Did it in an evening.

There are actually 3 parts to the skylight. The outer dome, a plastic decorative inner part (that probably has some purpose..), and the inner dome.

Be very careful and measure the outside dimensions of the flange. I found a replacement from Icondirect. Seems to be good quality. Shipping was too high, but I had to get it done.

I put a fresh "patch" of Eternabond tape around the hole, then caulked a bead of skylight sealant on the skylight and screwed in place with stainless steel deck screws. Caulked sealant around edge and on screw heads, then put more Eternabond over that...

I also had to fix a factory screw up. When they screwed the plywood down they crushed the seam where it met the skylight hole. I removed the two screws and built it back up with shims, then replaced the screws.

Came out great. Toughest part was getting all the old caulk off but it wasn't as bad as I thought it was going to be. I'm sure others will have tips to make it easier.

Max
2010 Silverado 2500HD Duramax/Allison Crew
2000 25' Sunnybrook
2010 Honda SH150

MrWizard
Moderator
Moderator
iirc

they are molded as double layered, and you replace the whole thing

just get the same one
remove all the screws
lift off
clean roof, new sealant, replace

just like replacing a roof vent
I can explain it to you.
But I Can Not understand it for you !

....

Connected using T-Mobile Home internet and Visible Phone service
1997 F53 Bounder 36s

Road_Runners
Explorer
Explorer
It should be easy to repair. Buy a new skylight and install it.
It is good that, that is all that was damaged.
'05' F-250 Power Stroke
'00' 30' Cameo Fifth Wheel