I installed a
cheap backup camera on my 78 terry trailer a while back. I ran the video cable inside the back wall (of the trailer) and along the bottom rails, where it ended as a 4-pin aviation plug. I added an aviation plug to the truck side and ran the wire along the frame rail, through the back floor and out the center console, where I mounted another plug. Then I could plug in the monitor so I could use it from the cab.
My new Rockwood mini lite has a mount for a Furrion wireless in the back, so I'm assuming thats where I'll get 12v from. I cant justify paying that much for a camera, so I'm looking to buy another cheap one. I think I can design and 3dprint a mount that will fit with what they have mounted up there.
I would go with a wired setup again, but I'm not sure how I would run the cable and make it presentable. Drilling holes in the side of the trailer is not an option at this time, so wireless is what I am looking at.
Has anyone tried the
Wireless 7" Backup Rear View Camera? It's quite a distance from the cab to the back of the trailer.
Once I get this figured out, I'll pass along the STL file I come up with for 3dprinting a mount.