Furnace/water heater

[dmark67]

Propane flowing - stove works.

Furnace and water heater will not start?

[pianotuna]

dmark67 remove all power to the furnace. Wait ten minutes. Pray to the propane gods and restore power.

[dmark67]

Hint:

Propane water heater and stove are working. I took the outside cover off the furnance and there is a circuit board with a red light blinking. Did the reset, no luck. All of my manuals say contact the dealer lol.

Ideas?

[Boon_Docker]

Old-Biscuit wrote:

schlep1967 wrote:
Both run off 12 volt. Is the battery charged and the battery cut-off switch turned on?

This^^^^

Propane is common but stove OK then DC Voltage is the other common component

***first time trying furnace/water in awhile......then could be propane flow
Might have to try each appliances several times to establish full flow/pressure at each one

^^^^
That was more than likely the problem.

[dmark67]

It's cold, from 0-10 degrees. I waited several hours and now it works...

On shore power and not DC, no problem with anything else (TV, microwave, etc.).

Got to hot in the middle of the night?

[Old-Biscuit]

schlep1967 wrote:
Both run off 12 volt. Is the battery charged and the battery cut-off switch turned on?

This^^^^

Propane is common but stove OK then DC Voltage is the other common component

***first time trying furnace/water in awhile......then could be propane flow
Might have to try each appliances several times to establish full flow/pressure at each one

[pianotuna]

Hi dmark67,

Welcome to the forums.

May I ask how cold it is outside?

[schlep1967]

Both run off 12 volt. Is the battery charged and the battery cut-off switch turned on?