cancel
Showing results for 
Search instead for 
Did you mean: 

Toilet Inlet fitting gasket

dhull
Explorer II
Explorer II
Changing out a Thetford style II toilet. At the water Inlet from camper the fitting has a rubber gasket inside it. Tried picking it out but it does want to pop out. It's a little deformed and previously leaked until tightened.

So I'm wondering if it should pop out and I can replace it. Or is it built in to the fitting?
Is this the PEX stuff?


4 REPLIES 4

dhull
Explorer II
Explorer II


Did get it out.
Thanks!

ScottG
Nomad
Nomad
Yes, it will pop out and you can get a replacement at HomeDepot like the part Mr. Wolfe shows above.

wolfe10
Explorer
Explorer
Could be a common RV washer: https://parts.unitedrv.com/products/1-2p-cone-washer

The little tabs keep it in place/a little more difficult to remove.

Any RV shop will have them.
Brett Wolfe
Ex: 2003 Alpine 38'FDDS
Ex: 1997 Safari 35'
Ex: 1993 Foretravel U240

Diesel RV Club:http://www.dieselrvclub.org/

QCMan
Nomad III
Nomad III
Most fittings will leak until tightened. Clean it and tighten it so it does not leak. They are fairly resilient.

2020 Keystone Cougar 22RBS, Ram 1500, two Jacks and plenty of time to roam!
The difference between genius and stupidity is that genius has its limits. A.E.
Good Sam Life Member

Type a product name