kraviks wrote:
So, I got distracted while hooking up after a weekend out in our 2012 Keystone Passport.
I started to raise the tongue and quickly realized I hadnโt retracted the stabilizer jacks. When I closed the Slide it seemed to catch. Had to work it a bit. (Figured I needed to adjust the cables).
When emptying the black and grey water tanks there was a pretty good leak coming from the valve area. Hard to tell exactly where as the underside is insulated.
The trailer did pull fine coming home with no issues. Could I have bowed the frame like a banana? Or is all this coincidental?
Hi,
You may have a few issues going on at the same time, or they are related. Need some more info to help better. Let's start here,
Having had to deal with camper bent frame rails and slides before, help us with this info as a start.
1. What model camper is your 2012 Passport? The floor plan helps us understand where the slide opening in the camper is in relation to the trailer tires/suspension. Ideally, you can post a picture of the slide side of the camper, with a pic showing from the back wall to the front ball coupler. We can see the relationship between the slide opening, wheels/axles, and the dump piping.
2. When you realized the rear stabilizers were down (and the front too, but they would not hurt, but the back ones could), you stated when you closed the slide, it caught. Tell us, was the tongue jack still up in the air from the initial jacking up when you brought the slide in, and the slide caught? Tell us when the slide came in and where was the tongue jack at that time. Still up high, back down to normal level, etc.
2A, As was asked, how high did you jack up the ball coupler above the level camper to start the hitch-up process when you discovered the jacks were still down? 2", 4", 6" etc. Knowing your floor plan can help as 19 ft camper may have more issues then a 30 ft camper when the tongue is 6" higher then level camper and the jacks are down.
3. You said you thought the cables needed to be adjusted. Heads up, wait to start adjusting the cables until we sort out how the slide caught.
4. Do you know what brand of slide cable drive you have and, ideally, the model of the slide drive? Is it the BAL system?
5. Tell us what caught on the slide when it came in? Examples might be: the lower rear corner, upper rear corner, etc.
6. Regarding the water leak, we need to know how the tank, piping, and dump valve location relates to the tire/axle location. If yours has the cover on, this will be hard to see or know, but I wanted to ask if you know. Do you? Was the leaking water grey or black water, if you could tell? Trying to connect the dots on how high the camper was raised, where the pipes are located, and whether that amount of movement cracks a pipe going into the tank. Since your camper is a 2012 model, it could have some miles on it, pending how they mounted the tanks and pipes into the tanks; normal frame flexing from towing can start a crack in the joint of the discharge pipe going into the waste tank. Your event may have been the last straw to an already fatigued joint. You or we do not know if it is a cracked pipe, but I have repaired cracked pipes going into the tanks due to frame flex over time in just normal higher mileage towing. Generally, the grey tank, the pipe routing, and the pipe straps did not leave any room to flex, so when the frame flexes, the pipe flexes at the joint into the tank. Over time, the joint starts leaking.
Hope this helps,
John
2005 Ford F350 Super Duty, 4x4; 6.8L V10 with 4.10 RA, 21,000 GCWR, 11,000 GVWR, upgraded 2 1/2" Towbeast Receiver. Hitched with a 1,700# Reese HP WD, HP Dual Cam to a 2004 Sunline Solaris T310R travel trailer.
