Oct-30-2019 12:18 PM
Nov-06-2020 04:42 AM
Huntindog wrote:
Do not use a grease gun on your axles.
In order to use this zerk feature, and completely purge the old grease out (maybe) it would take almost 4 tubes of grease at each greasing.... And it would most likely get past the inner seals and onto the brakes.
That creates quite a mess... Just don't do it.
Nov-02-2020 02:27 PM
Nov-02-2020 02:07 PM
Nov-02-2020 05:32 AM
Huntindog wrote:
I just looked at the maintenence schedule on Dexters site.
It states that annual inspection of the bearings is REQUIRED.
Since an inspection means you gotta disasemble it..... You might as well hand pack them at that time....Which means that the EZ lube feature is worthless. All downsides and no upsides.
Oct-27-2020 03:25 AM
Oct-26-2020 05:35 PM
campigloo wrote:You seem like the really smart silent type. Thanks for posting i will remember your advice.
The void in the hub is meant to dissipate heat. Don’t fill it with grease. Best to grease and inspect them by hand.
Oct-26-2020 05:17 PM
Oct-24-2020 09:20 AM
Oct-23-2020 05:29 AM
bpounds wrote:
Problem with that ^ theory is that there is a rubber boot built into the hub cover cap that expands to relieve any pressure. On hot runs I see those boots bulged outward and cold they are pulled inward.
Oct-22-2020 08:55 PM
Oct-22-2020 08:31 PM
Oct-20-2020 11:35 AM
Oct-18-2020 11:04 AM
Oct-18-2020 09:20 AM