โJun-20-2022 01:42 PM
โJun-21-2022 04:36 PM
โJun-21-2022 02:44 PM
TheLostBoy wrote:
Oh man, that's a good solution, but how could I drill through this threaded rod? I'd rather not take them off to put into a vice, but I assume they wouldn't stay very still.
โJun-21-2022 12:51 PM
โJun-21-2022 10:24 AM
โJun-21-2022 08:24 AM
JRscooby wrote:
If you have enough thread there, screw on 2 nuts, then jam them together. Work same as welding, but if you need to take it apart you can
โJun-21-2022 08:09 AM
โJun-21-2022 07:53 AM
โJun-21-2022 04:41 AM
JRscooby wrote:
If you have enough thread there, screw on 2 nuts, then jam them together. Work same as welding, but if you need to take it apart you can
โJun-21-2022 03:22 AM
โJun-21-2022 01:25 AM
โJun-20-2022 09:22 PM
โJun-20-2022 05:52 PM
โJun-20-2022 03:48 PM