Hello, I'm sure the answer to my question is here somewhere but I have been unable to find the information. I am attempting to install a Honeywell RTHL2510C 7 day programmable thermostat in my 2008 Lance 1181. I installed a 5-2 programmable Honeywell...
I finally have my solar installed, I want to thank all who gave me feed back and advise Calling Solar Gurus. I knew I was going with the factory installed solar wiring in my 2008 Lance 1181 so I decided to go with the Morningstar TristarTS-MPPT-45 Ch...
With the Texas heat we are using our on board generator more than I thought we would to run the a/c. The exhaust comes directly out of the back of our Lance 1181, right beside the entry door. I've already decided to install a 90* pipe and direct the ...
It's time to pull the trigger and install solar on our 1181. I'm planning to order within the next month to be ready for a trip near the end of summer. The TC is pre wired for solar. I've decided to wire in series, use a mppt controler and use the ex...
The DW and I are planning on going to Crystal Beach TX in the near future for a day or 2 on the beach. We go to Galveston a good bit but have always stayed in the RV parks. One of the main reasons we got the truck camper was to take short trips, stay...
You might try and call Lance, it has been about 5 years ago but when I was rebuilding a 1987 9000 they emailed me the drawings for the model I was working. Like kohldad they were hand drawn. I don't remember now exactly how I contacted them but I thi...
I swapped the thermostats out and did a few test. Again the a/c unit is operating normally with the Honeywell thermostat but still no heat. I have White/12DCV (-) to B, Green/fan high to G, Yellow/compressor to Y and Red/12DCV (+) to R. With the B/W ...
So looking atvthe information I've got in front on me it looks like the a/c unit is a RVP Products 9000 series and the furnace is a Atwood 8500-IV 2 stage series furnace. According to the wiring diagram I found on the furnace paper work the furnace s...
westend this crossed my mind but since the White is listed in the wiring diagram as a system ground, negative circuit on the 12v system, and the Blue/White as a furnace ground I don't this that will work either, beside I touched the wires together an...
I did quite a bit of research before I decided how I wanted to set my system up. I read handybobsolar, good information but I realized early on that if I followed everyones good advice, I'd be several thousand dollars into a system that was much more...
