All ActivityMost RecentMost LikesSolutionsRe: 750w of solar for $525 in Denver.I would like the info. I am rigging up for solar but do not want the expence of shipping so am waiting to head west in a couple of months and will get the panels then.Re: Residential toilets dont belong in RVsFema trailers have residential toilets, stoves and refrigerators.Cheapheat install in a WinnebagoHas anyone installed the RVComfortSystems Cheapheat in a Winnebago product? If so did it have the propane furnace going into the plenum box from the side? I am ordering mine and was just wondering how you attached the cheapheat and ran the wires with this configuation. Thanks for your help. This is a discussion on this install I really don't care for anyones opinion on the unit itself.Re: Is My ATS going badThanks, Chris, It could be just my old mind not remembering properly. I will give it a check. thanks for your imput.Is My ATS going badUsually I turn off all high draw items and start the Generator before I leave a campsite and the go out and unplug the electrical cord and do the reverse when I get to a new camp site (turn off al high draw items and the plug in the electrical before turning off the generator) In the past there was no problem. The Power Management System would show generator power only until I shut the generator off and then would show 50amp if that is what I was plugged into. And iff I were to start the generator before I unplugged the electrical cord it would show 50amp until the generator came on line and then switch and only show the generator. Lately it has been showing both sources at the same time. I have quickly removed one of the power sources as soon as I saw this. So is my Automatic Transfer Switch gone?Re: PressurePro SystemThe pressure pro tpms sending units batteries are not comsumer replaceable. they must be sent back and they will sell you new ones for a reduced price $35 i think.Re: front furnance not working on 2004 vectraI had the same problem this year with my 04 itasca meridian. The suburban sh42 furnace would not do anything. It ended up being the circuit board. I got a replacement from dinosaur boards for just over $100 and the change out was easy once you remove the furnace for access. If yours is like mine the access is next to the hot water heater remove the screws that hold the cover plate in place and then disconnect the propane line and then 1 screw for the furnace and out it comes. unplug the wiring harness and move the furnace to a work bench.Re: Slide won't come in-helpYou are talking about the drivers side flat floor sldie aren't you. If the engine running does not help the have someone push on it while you push the button and once it gets up the ramp it should come right in.Re: Slide won't come in-helpTry cranking the engine nd trying again. Sometimes that slide needs to have the battery a little more charged.Re: Heated Water HoseI got the Pirit hose as a gift last year and finally had a chance to use it this past week. It didn't work worth a toot. I am going back to the old school heat tape and pipe insulation like I have been using for the past 6 years. Never had a frozen pipe with the heat tape.