โDec-08-2013 07:55 AM
โDec-11-2013 05:35 PM
Jerry Campbell wrote:Friday (mebbe Thurs) before the show.
Thanks Jeff,
Good luck with the firmware update.
When do you think you will get here?
Jerry
โDec-11-2013 07:03 AM
โDec-09-2013 05:21 PM
Jerry Campbell wrote:The new firmware is now apparently fast and smart enough to take care of a failed engine or spun prop on the Hex with essentially no affect other than payload is reduced. I'll probably load and flight test out in Q. Don't think I'll have any time before that
From what I've read, most flight controllers have had similar issues.
I have not been able to afford a Naza. I have a Rabbit I and two Crius AIOP's one V1 and one V2.
The V1 is on a DJI 450 Clone and the V2 is on an 550 alien/dead cat frame that I'm building.
Too much fun. I also have a 32" wing.
Living in a bus limits the size of everything.
โDec-09-2013 04:43 PM
โDec-09-2013 03:37 PM
Jerry Campbell wrote:Don't remember, I think it was that one. Lemme go back and see what I can find.SCVJeff wrote:
If you're on the RC Groups forum, post this question there as well. one of the Quartzsite residents and his wife (the club treasurer) are very active there and will likely respond directly.
He did for me.
Thanks Jeff, I have been on RCGroups for a couple of years. Mostly on MultiRotor Electronics. Which forum did you ask on?
Thanks
Jerry
โDec-09-2013 07:48 AM
SCVJeff wrote:
If you're on the RC Groups forum, post this question there as well. one of the Quartzsite residents and his wife (the club treasurer) are very active there and will likely respond directly.
He did for me.
โDec-08-2013 09:39 PM
โDec-08-2013 04:11 PM
somewhere in the texas 'lost pines'
โDec-08-2013 12:40 PM
โDec-08-2013 08:46 AM