LED strip light install

[sjturbo]

Finally done. Very tedious but clean. Remote sensor is in the running light.

[Lenny_K]

Remotes are easy to find and buy on Amazon and are real cheap.

[sjturbo]

Nope! Hope that does not happen. But should it I think I can figure out something.

[4x4van]

Do you also have a manual switch for if/when you lose or misplace the remote?

[bob213]

Thank you for the info. Nothing better than directions in English!

[sjturbo]

Thanks for linking!
I connected directly to an open 12V circuit on my converter > 14g silicone wire to the terminal block > terminal block to LED receiver > LED receiver to 16' LED extension via internal channel for the awning power > to LED light strip, (siliconed connection). Located the hole and connection for the running light. Drilled a small hole in the running light plate and ran the remote sensor to the hole. Done. I left out the 2hours plus that I used an electrical fish tape to run the 16' extension through the horizontal frame channel that was used for the awning power. Hope this helps.

[bob213]

Looks good. Did you hook directly to 12v? Can you do away with the AC to DC converter?

[IAMICHABOD]

Nicely done,I made your parts list clickable so it would be easier if anyone wanted to do the same thing.


https://www.amazon.com/gp/product/B07GB5RMC4/ref=oh_aui_detailpage_o08_s00?ie=UTF8&psc=1.

https://www.amazon.com/gp/product/B01G6Q9S54/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1

https://www.amazon.com/gp/product/B07FMTCHC1/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1

https://www.amazon.com/gp/product/B01CG2HI0E/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1

[sjturbo]

This should include all the parts I used. Except for the 9v adapter cable which I had from my guitar pedal spares.
LED Strip
https://www.amazon.com/gp/product/B07GB5RMC4/ref=oh_aui_detailpage_o08_s00?ie=UTF8&psc=1.
https://www.amazon.com/gp/product/B01G6Q9S54/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1
https://www.amazon.com/gp/product/B07FMTCHC1/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1
https://www.amazon.com/gp/product/B01CG2HI0E/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1
Couple of additional pics

[dalenoel]

What parts did you use?

[Helmsey]

Looks good!