compartment door latch 96 Wbago Vectra

[base1957]

Looking for two of these if anyone has any?
Bago no longer makes em
thanks in advance


9 101348-01-000EABOLT-SLIDE, LATCH - NYLON - W/SPRING & BRKT
http://www.winnebagoind.com/service/wincd/1996/96km34rq.pdf

[base1957]

Thanks olfsrmer

[olfarmer]

Try 'Winnebago parts.com' in Hanlontown, Iowa. They are not part of Winnebago but handle a lot of Winnebago obsolete parts. I have had good luck with them.

[enblethen]

I am guessing that the plastic plunger broke.
I know it is more work, but could you change them out to ones like this?
Latch assembly

[MrWizard]

base1957

Helpful hint
Hold phone sideways like a normal camera
Take picture instead of screen capture
Upload normal horizontal camera picture
Shows more detail without the icons on the vertical picture, better picture

[Executive45]

base1957 wrote:
in fact executive... i looked for the way to do that... and still cant find it ...the only way i was able to do it is because you sent the HERE link... where do i find that in this rv net site?
thanks in advance

Click the HERE above and then hit CTRL D to bookmark the link. Saves lots of time.....Dennis

[base1957]

enblethen

Moses Lake, WA



had two that broke.. i think someone either tried to break into it or just pulled it real hard.
thanks for your help






Posted: 10/17/20 04:37pm Link | Quote | Print | Notify Moderator
What is wrong with yours?

[enblethen]

here is another place that might help you.
RV parts

[enblethen]

What is wrong with yours?

[base1957]

Thanks for the suggestions so far...i tried Colan amd no luck...
Making a couple may indeed the best idea

[base1957]

Thanks for the suggestions so far...i tried Colan amd no luck...
Making a couple may indeed the best idea

[enblethen]

try Colaw as they have many RV parts both new and old. Send them the photo.

[DrewE]

You may well be able to get used but serviceable ones from an RV salvage yard.

Failing that, in your shoes I'd probably see about constructing a replacement part, say by cutting and drilling a piece of square aluminum stock. It doesn't look like too complicated of a piece: an angled end for the latch itself, a hole for the pull rod, and a hole for a cross-pin to catch the spring.

One could also 3D print (or have 3D printed) the bolt of the latch once the design is reproduced in a CAD or other 3D design program; printing in nylon is possible but somewhat tricky and requires a printer more capable than the basic models (and likley an enclosure). I'm not sure PLA or other more common 3D printed plastics would hold up all that well here.

[emiddleb]

It in the "Technical Resources" => "Forum Posting and Help" subforum, third sticky down. "RV.net and Picture Related FAQs" posting.

[base1957]

in fact executive... i looked for the way to do that... and still cant find it ...the only way i was able to do it is because you sent the HERE link... where do i find that in this rv net site?
thanks in advance