โDec-10-2009 06:16 PM
โJan-16-2011 01:56 PM
bdosborn wrote:oldtrucker63 wrote:
Still have not made up my mind on just what I will be using on the floor Carpet or something else, I do have the floor tile for the bathroom
I did linoleum with a carpet runner, and I think its the best of both worlds. Linoleum for easy cleaning and a carpet runner so the floor isn't so cold. Sweep the Linoleum, shake out the carpet runner and you're clean.
Bruce
โJan-15-2011 01:42 PM
oldtrucker63 wrote:
I have a new brain storm here, I was sitting out in the RV today and got to thinking although I was thinking with this worn out brain of mine, Anyway, I'm thinking of running the heat from the furness up the corner of the wall with a 2 1/2 inch PVC pipe and then running the heat out from the ceiling area with 4 outlets One in the bath area and one in the rear bunk area and one about middle ways and one in the overhead bunk, The place that the PVC pipe will run from the furness up to the ceiling will be boxed in so the PVC can not be seen, The way I see it This should work great, We will see.:h
โJan-15-2011 01:25 PM
โJan-15-2011 12:44 PM
โJan-15-2011 12:41 PM
โJan-15-2011 12:25 PM
oldtrucker63 wrote:
Still have not made up my mind on just what I will be using on the floor Carpet or something else, I do have the floor tile for the bathroom
โJan-15-2011 07:28 AM
โJan-15-2011 07:20 AM
You mean like clothes dryer vent tubing. That is what our RV has.
โJan-15-2011 03:18 AM
oldtrucker63 wrote:
Still have not made up my mind on just what I will be using on the floor Carpet or something else, I do have the floor tile for the bathroom.
โJan-14-2011 06:57 PM
tenbear wrote:
Hot air rises so, having the outlets in the ceiling may not give you the best distribution of heat, but if that is the only way of getting the ducts to where you want the heat it may be the best approach. Most of the ducts in my rig are 4".
โJan-14-2011 05:38 PM
TreeSeeker wrote:You mean like clothes dryer vent tubing. That is what our RV has.
Oldtrucker,..I am not sure I would want to use PVC due to possible outgassing. Why not just use standard flexible aluminum vent material?
โJan-14-2011 05:17 PM
โJan-14-2011 04:48 PM
โJan-14-2011 03:35 PM
โJan-14-2011 03:26 PM