โMar-24-2015 06:18 PM
โMar-26-2015 11:46 AM
โMar-26-2015 11:20 AM
โMar-25-2015 11:03 PM
โMar-25-2015 06:43 PM
โMar-25-2015 06:15 PM
rvluckyorwhat wrote:
dougrainer:
-Of course I checked the spray arm first, which is why I never mentioned it.
-I've been talking about the pressure and/or flow being too LOW from the very start (not too high).
-While I agree 50 psi is probably CYA, going above it would not be covered should something go wrong so that is not my preferred route at this time unless I can find specs to support going higher.
-I agree that a hose kink seems like a likely culprit. I'm trying to figure out the best way to pull the DW from my cabinetry without damaging anything. It sits above a drawer, not directly on the floor. Any suggestions?
โMar-25-2015 06:04 PM
โMar-25-2015 04:04 PM
โMar-25-2015 03:36 PM
rvluckyorwhat wrote:
Really AllegroD, 55 psi seems low? My manufacturer is telling me not to exceed 50, but now you and Myredracer are both suggesting a higher pressure.
โMar-25-2015 03:21 PM
AllegroD wrote:rvluckyorwhat wrote:
Really AllegroD, 55 psi seems low? My manufacturer is telling me not to exceed 50, but now you and Myredracer are both suggesting a higher pressure.
Yes. That is why I asked what Thor said. I do know that not all mfgr use same standards. So if Thor says to use 50, then I would not exceed their recommendation. I have a Tiffin Allegro 36LA. It is tested at 115. I use 65 on my regulator without fear or incident.
โMar-25-2015 03:13 PM
rvluckyorwhat wrote:
Really AllegroD, 55 psi seems low? My manufacturer is telling me not to exceed 50, but now you and Myredracer are both suggesting a higher pressure.
โMar-25-2015 01:07 PM
โMar-25-2015 01:04 PM
โMar-25-2015 12:24 PM
โMar-25-2015 11:39 AM