โMar-06-2014 01:08 PM
โMar-10-2014 06:56 PM
โMar-10-2014 06:18 PM
โMar-10-2014 03:13 PM
โMar-10-2014 01:53 PM
โMar-10-2014 01:36 PM
dougrainer wrote:Gau 8 wrote:
Upon further study of the manual, the relays 1-4 are normally open. However, the low voltage relays use the normally closed position to control the ACs. So, if you pull the fuse, both ACs should work.
Only 1 AC is shed controlled. Usually the rear AC. Sorry, pulling the fuse will not allow power to ANY shed controlled appliance. There are only 4 relay's. Where you are mistaken in your reading is the section about COMPRESSOR shedding, NOT the complete AC power. Some AC systems allow the Compressor to NOT have power to come on instead of the Complete power to the AC shut off. That means the fan will still have power to run, but the Intellitec system tells the AC control board to not allow the AC onboard compressor relay to energize and close to allow the compressor to run. As I stated, when an Intellitec system malfunctions, NONE of the shed controlled appliances will operate. Doug
โMar-09-2014 04:29 PM
bobmacc wrote:
I believe the Intellitec system operates on 12 volts. Try shutting the 12v down and the system will reboot when you turn it back on. I had a problem similar to your which made the Intellitec do odd things. Turned out it was a problem in the power pedestal but make sure all your connections are tight in the breaker box and transfer switch as the symptoms would be identical. I also had an issue with it not showing 50amps service when connected - turned out the sense lead was connected to a breaker that I had turned off. Good luck,
Bob
โMar-09-2014 03:42 PM
โMar-09-2014 06:31 AM
Gau 8 wrote:
Upon further study of the manual, the relays 1-4 are normally open. However, the low voltage relays use the normally closed position to control the ACs. So, if you pull the fuse, both ACs should work.
โMar-08-2014 05:33 PM
โMar-08-2014 05:04 PM
โMar-07-2014 06:01 AM
โMar-07-2014 04:10 AM
Gau 8 wrote:
I thought the relays were normally closed .
โMar-06-2014 04:28 PM
โMar-06-2014 01:49 PM