What System panel do i have?

[Rycher]

I cant find any info on this thing. anyone seen this before and know the manufacturer?

[Rycher]

just fyi for all.. i was able to pull it out far enough to see its a geckotech model ecp. very similar to the KIB's on the market..

[mobeewan]

Might be able to take the screws out and pull it out far enough to see if there is amfg and moder number. Worse case might need a flashlight and or mirror.

[Dusty_R]

3 tons wrote:

Dusty R wrote:
Not what you are asking, but check out "Sea Level" tank sensors. A much better system given levels in %. And not very hard to install.

Actually, ‘SeeLevel’ by Garnet.

Good catch, thanks.

[3_tons]

Dusty R wrote:
Not what you are asking, but check out "Sea Level" tank sensors. A much better system given levels in %. And not very hard to install.

Actually, ‘SeeLevel’ by Garnet.

[Dusty_R]

Not what you are asking, but check out "Sea Level" tank sensors. A much better system given levels in %. And not very hard to install.

[Dutch_12078]

KIB has made panels similar to that one for many years. If your tanks have the common 4 wire "studs through the tank wall" sensor setup, then it's likely KIB. Here's a link to their current version of that panel:

KIB® - M21 Tank Monitor System Panel

[larry_cad]

I would take out those two screws, and remove the device so I could look at what is on the back. Probably a manufacturer name and model number.