I had the air conditioner compressor upgraded on my 93 Southwind with a P30 chassis and a GM 454. I believe Im on the 3rd belt in 3 years. It has 2 belt positions but only 1 belt because the crank, water pump and power steering pulls only have 1 spot...
Question for anyone in the know. I have a 2014 Nissan Versa Note that I tow with an Acme dolly. The front wheel bearings had to be replaced with only about 3300 miles of towing. There was a lot of lateral movement I noticed when I had a flat on the l...
Has anyone had any problems with losing the rubber grommet that holds the led lights in the light mount on an Acme tow dolly. Lost both grommets on a 200 mile trip. I checked them both to make sure they were seated properly when I installed them.
Has anyone towed specifically a 2014 Nissan Versa Note with a Acme Tow Dolly. Ive heard nothing but good about them but wonder because of the Versa's low clearance if the dolly might rotate up in the back and damage the little fender flaps that hang ...
Thanks for the replies. I may have 9000 miles on it since I had the compressor changed and this is the 3rd belt. The Winnie site has some good info. The 1 drawing of the belt layout looks to have 2 belts on the comp. Ill keep looking.
I See everyone say leave the steering wheel unlocked. Dont y'all think you should also leave the car in neutral? The dolly is going to rotate the front wheels going over humps and dips. Or am I just talking about the obvious. Maybe the book sez to le...
Hoss sounds like you have tested pretty good. Yeah the book sez 90psi. I have a hard time putting that much in a small tire like that. Do you run with the ramps bolted down in the spot for them in front? The Versa doesn't have much clearance and Im a...
