โAug-18-2014 05:16 PM
โJul-08-2015 12:17 PM
jyrostng wrote:darsben wrote:
I am adding this to my knowledge base
Even with the new cap and rotor it started popping again. I found a bad plug wire on the #4 plug, no damage to the outside of the wire. I had to use a Ohm meter to find it. I suppose the HEI dist has so much voltage the spark found the lowest point of resistance with the bad wire was another post inside the dist cap causing another cylinder to fire while the intake valve was open causing the carb pop.
I also did this to fix the over heating plug wire problem on all these p30 chassis.
P-30 P30 plug wire and header overheat fix
โJul-08-2015 11:25 AM
โOct-02-2014 07:40 PM
BULLETLS1 wrote:
I found in the SUMMIT RACING store in Ga, an offer: complete billet HEI distributor, with hi perf coil, module, and cap-rotor for $57!!!, still carry the old one (of course had installed new wires).
โSep-14-2014 10:25 PM
โSep-12-2014 07:19 PM
โSep-11-2014 10:53 AM
โSep-11-2014 10:00 AM
darsben wrote:
I am adding this to my knowledge base
โAug-19-2014 11:33 AM
โAug-19-2014 09:01 AM
โAug-18-2014 08:04 PM
โAug-18-2014 07:20 PM
โAug-18-2014 06:25 PM
โAug-18-2014 06:24 PM
โAug-18-2014 05:51 PM