cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

Water Pressure Regulators

rvnubee
Explorer
Explorer
I am researching water pressure regulators for my new motorhome. I am reading that this is recommended to prevent potential damage due to high water pressure sources. Is it necessary to get an adjustable unit or is one that I found pre-set at 40-50 PSI good enough?
31 REPLIES 31

et2
Explorer
Explorer
https://www.rvwaterfilterstore.com/Adj.htm

263 ALF is what solved all our pressure and flow problems. Adjustable. Have had it over 5 years. Set at 55 Psi

time2roll
Nomad
Nomad
I have a fixed pressure regulator given to me by the dealer as part of the RV start kit. Probably the lowest cost item available although it is made of brass. Works fine in all conditions for me since 2005.

down_home
Explorer II
Explorer II
We have the fixed 40lb pressure regulator on ours right now. Not satisfied. Of course water goes through filters first so it still works.
Bought one of the adjustable ones from CW didn't work CW wouldn't take it back a year later when I thought bout it.Bought another one. Hope it works.
It would be helpful to have a pressure gauge to know what the pressure is at the faucet where we connect. I prefer 85 lbs. Get a nice shower that way.
So when I get the time I need a to find a pressure gauge to put before the regulator. None of them flow the 5.3 gph at 65psi that the in house pump from tank does. So sometimes I fill the tank and turn off the faucet and use the onboard pump. 100psi will clean out your rv great if the fittings let go on your water hose/pipes. At 85 psi ours at one camp ground we like, so far so good.
Really blast the dirt off the rig too, if the hose doesn't burst or ends blow off. Lost two or three of the little white cheap hoses, from faucet to filter, from CW from bursting right at fitting and blowing them off.Have good blue lined hose now but still need a short one or two.

Bob___Ann
Explorer
Explorer
We also use a Watts regulator as a portable. I have a section of hose with adaptors that go into the Watts which is followed by a pressure gage. We camp about 180 nights a year and have used it for five years. We keep it set on 50 pounds. Yes some campgrounds especially in the San Antonio area can have as much as 160 pounds pressure. You will find many campgrounds in your travels that never get over 40 pounds like Virginia Beach in peak season. If the pressure gets to low you can fill your fresh water tank in the campground and then run your pump which will provide good pressure. The Watts has been a good choice for us.
Bob and Ann
Schnauzer - Della (Rainbow B 3/31/17)
Chihuahua - Lola (Rainbow B 12/26/18)
Autumn-Red Poodle
2019 Tiffin 40 IP Bus
Powerglide Chassis
Cummins 450
Onan 10,000 Watt
Four Slide/ 1.5 Bath
2021 Jeep Unlimited Sahara Toad
Demco Dominator & Airforce One

doxiemom11
Explorer II
Explorer II
We use an adjustable Watts with brass fittings. Have it set for 50#. Going on it's 8th year of full-time use. We tried a preset one the first trip out and couldn't even get any water to come thru it. Probably defective, but we returned it and spent more money for a better quality item.

Old-Biscuit
Explorer III
Explorer III
path1 wrote:
Old-Biscuit wrote:
Pre-set ones tend to be more restrictive and limit flow

Adjustable ones have higher flow ratings


Personally I use an adjustable set to 50#.......fill my fresh water tank and exclusively run off of pump. Constant pressure and flow regardless of where we go.

PLUS I don't have to worry/deal with a 'flood' like the one that happened in 2008 when on city water with regulator and fitting gave way while we were sleeping .....flooded the RV to the tune of $6000 in repairs/costs
No more city water hook up for us.
Fill tank use pump and with just a flip of the pump switch turn it off at night or whenever leaving RV evn when just gong outside......SIMPLE


THE best way to regulate water is to work off from water pump only. Search water damage on here, you'll understand why. On annual check list... test with air 80 percent of what your OEM spec is.


Fitting was cracked then finally fell apart.
Figured it got cracked during factor build....gorilla using channel locks :B
Is it time for your medication or mine?


2007 DODGE 3500 QC SRW 5.9L CTD In-Bed 'quiet gen'
2007 HitchHiker II 32.5 UKTG 2000W Xantex Inverter
US NAVY------USS Decatur DDG31

myredracer
Explorer II
Explorer II
The typical exterior inline pre-set regulators are rated for around 2 gpm or so. I installed a Watts 263A regulator inside which are good for 4-4.5 gpm. RVwaterfilterstore.com has a Fairview inline exterior regulator that is rated 10 gpm and 60 psi but is $35. I have our Watts regulator set at 60 psi as recommended by RVwaterfilterstore.com. RV water piping systems are supposed to be good for at least 100 psi.

The typical exterior inline regulators have a small orifice inside and a small regulator mechanism and can plug up with silt & debris quickly. The first inline regulator we had only lasted a year and have read of others having the same happen. They are not designed to be rebuilt, unlike a Watts regulator (or similar).

"Quality" regulators like a Watts publish flow vs pressure graphs like here for example but you won't find such a graph or specs for the exterior inline types so performance will be unknown.

I once tested an inline regulator at home by varying the input pressure from our well. It didn't regulate very well across varying input pressures up to about 100 psi. I didn't keep my notes but would be an interesting experiment for someone to try.

One thing about the exterior regulators to note is that they are best used at the faucet end of your hose and not the at the city water inlet so that the hose is protected against high pressure. However, it's possible to forget to remove it from the faucet. Some CGs can have pressures well in excess of 100 psi which can potentially blow a hose. I use a Valterra high pressure rated hose because our regulator is inside.

A gauge after the regulator is a good idea and also one ahead of it. The highest pressure we've encountered so far has been 120 psi.

If you are going to use a filter(s), they should be after a regulator because some filters will be damaged by high pressure.

path1
Explorer
Explorer
Old-Biscuit wrote:
Pre-set ones tend to be more restrictive and limit flow

Adjustable ones have higher flow ratings


Personally I use an adjustable set to 50#.......fill my fresh water tank and exclusively run off of pump. Constant pressure and flow regardless of where we go.

PLUS I don't have to worry/deal with a 'flood' like the one that happened in 2008 when on city water with regulator and fitting gave way while we were sleeping .....flooded the RV to the tune of $6000 in repairs/costs
No more city water hook up for us.
Fill tank use pump and with just a flip of the pump switch turn it off at night or whenever leaving RV evn when just gong outside......SIMPLE


THE best way to regulate water is to work off from water pump only. Search water damage on here, you'll understand why. On annual check list... test with air 80 percent of what your OEM spec is.
2003 Majestic 23P... Northwest travel machine
2013 Arctic Fox 25W... Wife "doll house" for longer snowbird trips
2001 "The Mighty Dodge"... tow vehicle for "doll house"

Lynnmor
Explorer
Explorer
rvnubee wrote:
Very good information! Thank you

I found this one from Camcothat is fixed at 40-50 PSI.

Am I understanding that this pressure is adequate for a shower, or no?

I will be pick up my rig next week and will try it out for myself but trying to do my homework in advance.

Thanks for the tips.


40-50 psi is just fine, but look at the views inside that unit. Ask yourself how there will be adequate flow thru all that junk. Pressure and flow are two different things.

buc1980
Explorer
Explorer
I have a Watts and I don't have any complains and is pressure adjustable.
2017 Ford F350 DRW,2005 Kountry Star 35ft,16750 lb weight on SAILUN tire,6 points LIPPERD Level-up.New Mor/ryde IS suspension install.Full body paint 2022.RV flex roof 2023

rvnubee
Explorer
Explorer
Very good information! Thank you

I found this one from Camcothat is fixed at 40-50 PSI.

Am I understanding that this pressure is adequate for a shower, or no?

I will be pick up my rig next week and will try it out for myself but trying to do my homework in advance.

Thanks for the tips.

Dutch_12078
Explorer II
Explorer II
I'm currently using a Valterra Lead-Free High-Flow Water Regulator (A01-1122VP). It replaces a failed Watts regulator that I was planning to rebuild, but the Valterra works so well that I've decided to use it permanently. In testing by a pump rebuilder, the Valterra flow rate and pressure stability were not significantly lower than the Watts regulator's ratings.
Dutch
2001 GBM Landau 34' Class A
F53 chassis, Triton V10, TST TPMS
Bigfoot Automatic Leveling System
2011 Toyota RAV4 4WD/Remco pump
ReadyBrute Elite tow bar/Blue Ox baseplate

Old-Biscuit
Explorer III
Explorer III
Pre-set ones tend to be more restrictive and limit flow

Adjustable ones have higher flow ratings


Personally I use an adjustable set to 50#.......fill my fresh water tank and exclusively run off of pump. Constant pressure and flow regardless of where we go.

PLUS I don't have to worry/deal with a 'flood' like the one that happened in 2008 when on city water with regulator and fitting gave way while we were sleeping .....flooded the RV to the tune of $6000 in repairs/costs
No more city water hook up for us.
Fill tank use pump and with just a flip of the pump switch turn it off at night or whenever leaving RV evn when just gong outside......SIMPLE
Is it time for your medication or mine?


2007 DODGE 3500 QC SRW 5.9L CTD In-Bed 'quiet gen'
2007 HitchHiker II 32.5 UKTG 2000W Xantex Inverter
US NAVY------USS Decatur DDG31

wa8yxm
Explorer III
Explorer III
Ok here are a description of several water pressure regulators and a comment.

one of the CG's I stay at when they hand you the campground info sheet/map it mentions the measured water pressure is in excess of 120 PSI (city water) Believe it. I've confirmed. this kind of pressure can blow the end off your hose and did blow up my Fresh water hose.. kind of like the cartoons where the character blocks the water flow and the hose gets bigger and bitter and KABOOM only not qute that impressive (Shot a stream not a flood)

Next page.

Small 3/4" cylinders, brass or plastic male hose end on one end, female on the other.... JUNK these restrict flow. OK for washing dishes but not for a shower.

HIGH FLOW. Like above but often have a bright Plastic-rubber grip on the female end (Camco puts Wings on the body of the plastic one) Better for washing dishes, Still not too restrictive.

Valterra adjustable (About 20-30 bucks) I have not yet tried one of these. but........ Others report good results with them.

Now I have a Watts 3/4 inch that needs a rebuld. and a ZURIN 3/4 Inch that is all but new. about 60 bucks each.

WHen I hooked up the ZURIN I put a pressure gauge on it and set the pressure (Static) at 50 PSI, then I turned on the shower and watched the needle on the gage.. NOT MOVE AT ALL.

When the Watts was new it did the same thing. but as they age.. Well they start to fail to fully open.. I'll get a kit and rebuild the Watts. and re-test it.

kits are not expensive and the job is easy.

These units have an "upper" hosuing that is bell shaped. the pressure adjustment is the bolt that would NORMALLY hold the bell to the yoke or handle. if it were a real bell
Home was where I park it. but alas the.
2005 Damon Intruder 377 Alas declared a total loss
after a semi "nicked" it. Still have the radios
Kenwood TS-2000, ICOM ID-5100, ID-51A+2, ID-880 REF030C most times

Lwiddis
Explorer II
Explorer II
Regulator or not, turn off the city water whenever you leave the campsite as a minimum. Some of us never stay hooked to city water but rather fill the onboard tank and use the pump. Busted TT water line is NO fun.
Winnebago 2101DS TT & 2022 Chevy Silverado 1500 LTZ Z71, WindyNation 300 watt solar-Lossigy 200 AH Lithium battery. Prefer boondocking, USFS, COE, BLM, NPS, TVA, state camps. Bicyclist. 14 yr. Army -11B40 then 11A - (MOS 1542 & 1560) IOBC & IOAC grad