โOct-02-2011 12:11 PM
โJul-21-2013 10:47 AM
j-d wrote:
How did you clean this carb?
How's it running now?
I got a tip on this site about getting the carb out from between the air filter housing and the manifold elbow:
Stick a screwdriver into the filter element bracket and spring the plastic housing and foam gasket away from the carb.
I backed out one of the screws that hold the housing in place and loosened another. Took a couple tries to get the screwdriver that pried best, but the carb came out and went back SO easily. Didn't take much, just enough to clear the choke plate. The way the carb's laid out, the choke and throttle won't both close. One sticks out making it hard to slip out and back in.
โJul-21-2013 10:46 AM
โSep-16-2012 08:38 PM
โSep-16-2012 06:02 PM
โMar-22-2012 01:31 PM
โMar-22-2012 01:30 PM
โMar-22-2012 06:34 AM
โOct-02-2011 06:24 PM
โOct-02-2011 06:09 PM
โOct-02-2011 05:48 PM
xjruss wrote:
Hello,
I have an Onan Microquiet 4000, spec K, in my Toy Hauler. I'm working through the typical gummed up carb issue, but failed to make note of the orientation of the choke/throttle levers and linkage rods.
Would someone be so kind as to post a pic or two of their carb, so I can see how this thing should look when assembled correctly?
Thanks in advance.
Regards,
Russ