โAug-22-2013 06:14 AM
โAug-23-2013 12:34 PM
โAug-23-2013 11:48 AM
โAug-23-2013 10:39 AM
Old & Slow wrote:
I also have the same meter. The right side of the meter is the load side (battery) and the left side is the Source (panel) The switch is needed in battery side so as to Disconnect the battery power (Red) for two seconds to reset for data readout. I've read the two reds are tied together in the meter. Hmm lot's of fun
I have my Watt Meter just handing below the MPPT controller in the shop connected to my 24v/120w Cynergy Panel and two 12v batts in series.
My Watt Meter was mfg for SUN-BORN Energy by Turnigy It's on EBay at $42.95 plus shipping.
O$S
Floyd
โAug-23-2013 07:58 AM
โAug-22-2013 07:02 PM
โAug-22-2013 12:30 PM
MrWizard wrote:
mine shows battery voltage
i get to record the overnight low voltage
mine is wired to the battety/output side of the controller going to the batteries
so the power red lead is connected to the batteries charge line, thru a switch i use as the reset
so it reads battery voltage even when the solar is off
every evening after taking my daily reading, i hit the reset
โAug-22-2013 12:29 PM
โAug-22-2013 09:51 AM
โAug-22-2013 09:32 AM
โAug-22-2013 08:57 AM
โAug-22-2013 08:54 AM
Snowman9000 wrote:
When a Turnigy is used to monitor charging, the charging source is the source side, and the battery is on the load side. If the charging source is off, will the meter show the battery voltage? It doesn't seem so from what I see of it.
There is an aux power input. If that was powered up, would it then register batt voltage in the above scenario?