โApr-18-2016 09:16 AM
โApr-18-2016 04:55 PM
fourscoot wrote:
I just spoke to Randy at Best Converters. The listed amp rating is the Maximum charging amps. It is a shared load, so the more amps being pulled by appliances and fixtures the lower the amps going to the battery.
โApr-18-2016 04:53 PM
โApr-18-2016 04:52 PM
โApr-18-2016 04:45 PM
โApr-18-2016 04:19 PM
โApr-18-2016 03:49 PM
โApr-18-2016 03:03 PM
โApr-18-2016 01:59 PM
โApr-18-2016 12:54 PM
โApr-18-2016 12:53 PM
โApr-18-2016 12:38 PM
Steve_in_29 wrote:
Xantrex Prosine2K invertor I went with had a much better charger built into it.
โApr-18-2016 11:38 AM
ISBRAM wrote:
I did the PD9260 conversation to my Magnetek a few years ago. I also followed the same instructions on your link. I think PD also has a plug and play converter that is easer to install but it costs a little more.
It only took me a few hours; I already had all of the required tools and skill to use them. It works great and I never have heard the fan come on.
My old Magnetek converter section always boiled the battery and later on it started to have a parasitic draw on the battery when unplugged.
โApr-18-2016 11:13 AM
โApr-18-2016 10:28 AM